• THE FRP HULL IS HAND-LAID WITH VINYLESTER RESIN IN OUTER LAYERS AND ORTHOTHALIC RESIN IN THE REMAINDER.
• THE HULL SIDES ARE CORED BETWEEN WL AND RUBSTRAKE. REINFORCEMENT CONSISTS OF A MOLDED FRP GRID BONDED THROUGHOUT THE HULL. BOTTOM.
• THE DECK AND SUPERSTRUCTURE IS A SINGLE FRP MOLDING WITH STRUCTURAL CORING AS REQUIRED
• NON-SKID FRP DECKS
• PORT & STBD BULWARK DOORS.
• MOLDED BOW & STERN SCUPPERS

EXTERIOR HARDWARE & FITTINGS
(316 SS UNLESS OTHERWISE NOTED.)

• S/S 1-1/4” RAILS MAIN DECK FWD AND BOAT DECK.
• 14” S/S RAKED BOLLARD CLEATS IN BOW & STERN
• S/S CLEATED CHOCKS MIDSHIPS
• SINGLE, S/S BOW ROLLER
• S/S WATER, WASTE & DIESEL DECK PLATES
• S/S TANK VENTS ON HULL
• S/S SUPPORTS FROM DECK TO SUN ROOF OVERHANGING COCKPIT
• 5, NATURAL COLOR, ANNODIZED ALUMINUM SLIDING WINDOWS IN SALON/GALLEY
• 8 S/S ALUMINUM PORTLIGHTS & SCREENS
• FLAGPOLE BASE & TEAK FLAGPOLE
• EMERGENCY TILLER ACCESS PLATE & EMERGENCY TILLER
• S/S ENGINE & GEN SET EXHAUST FLANGES
• 2 ZINCS
• BRONZE SEACOCKS
• BRONZE STRAINERS ON ENGINE INTAKE SEACOCKS
• S/S LOUVERED VENTS ON MOLDED FB SEATS
• 6 OVERHEAD LIGHTS ABOVE SIDE DECKS AND COCKPIT
• CHROMED BRONZE DOOR HARDWARE

MAIN DECK

• TEAK CAPRAILS ON PORTUGESE BRIDGE, BULWARK SIDES AND TRANSOM PARTIALLY TRIMMED WITH S/S HALF ROUND

PROPULSION, ENGINE ROOM & BILGE
CONTINUED:

• 1 MANUAL BILGE PUMP
• 3 EA 12V SHOWER SUMP PUMPS
• WATERTIGHT ENGINE ROOM BULKHEADS
• BRONZE SEACOCKS & STRAINERS ON ENG & GENERATOR SEAWATER INTAKES

FLYBRIDGE

• S/S DESTROYER TYPE HELM AT UPPER HELM & FULL INSTRUMENTATION
• CAPTAIN’S SEAT WITH FOOTREST
• MOLDED SEATS W/ STORAGE UNDER
• NON-SKID FRP DECK
• 1-1/4” S/S DOUBLE SAFETY RAIL AROUND UPPER DECK
• ALUMINUM MAST W/ RADAR BASE & LIGHTS
• PAINTED ALUMINUM BASES FOR P & S NAVIGATION LIGHTS
• HATCH OVER AFT ACCESS LADDER TO MAIN DECK
• S/S AND ACRYLIC DOOR BEWEEN UPPER DECK AND STAIRS TO PH
• TEAK BENCH SEATS ON LIFELINES

PILOTHOUSE

• CHART LOCKER
• TEAK AND HOLLY CABIN SOLE
• P & S S/ S DOORS, WITH SAFETY GLASS WINDOWS
• 7 FIXED WINDOWS WITH NATURAL COLOR, ANODIZED ALUMINUM, WITH SAFETY GLASS
• 3 PANTOGRAPH WIPERS
• INTERIOR STAIRS TO F/B
• LIGHTED STAIRWAY TO STATEROOMS
• UPHOLSTERED “L”-SHAPED SETEE WITH UNDERNEATH STORAGE
• ADJUSTABLE HEIGHT TABLE CONVERTIBLE TO BERTH IF CUSHIONS ARE ORDERED
• AC & DC RECEPTACLES
• VINYL HEADLINER THROUGHOUT THE INTERIOR, EXCEPTING THE ENGINE ROOM, INSTALLED WITH ALUMINUM HARDWARE
• S/S DESTROYER TYPE HELM WITH TEAK RIM & FULL INSTRUMENTATION
• CAPTAIN’S SEAT WITH FOOTREST
• OVERHEAD TEAK ELECTRONICS
• MOUNTING CONSOLE W/ EASY WIRING ACCESS

MASTER STATEROOM

• QUEEN SIZE BERTH WITH 5” FOAM MATTRESS COVERED IN CLOTH UPHOLSTERY
• 250 U.S. GALLONS WATER TANK UNDER BERTH
• PRIVATE LAVATORY WITH STALL SHOWER
• DRESSING TABLE WITH DRAWERS & SEAT
• MIRRORS
• BEDSIDE CABINETS W/ DRAWERS
• HANGING LOCKERS
• TV CABINET
• READING LIGHTS
• AC DUPLEX RECEPTACLES
• PHONE AND TV OUTLET
• OPENING, SCREENED PORTLIGHTS
• PADDED CARPET

PORT GUEST ROOM - OPTIONAL

• TWO SINGLE BERTHS W/ 5” FOAM, FABRIC COVERED MATTRESSES; UPPER BERTH FOLDS UP AGAINST WALL
• DRAWERS UNDER LOWER BERTH
• HANGING LOCKER
• FULL LENGTH MIRROR
• READING LIGHTS
• AC DUPLEX RECEPTACLES
• OPENING, SCREENED PORTLIGHT
• PADDED CARPET

PORT OFFICE INSTEAD OF DOUBLE GUEST ROOM - OPTIONAL

• MARBLE TOP, TEAK DESK W/ LEGAL SIZE FILE DRAWERS
• DESK LIGHTS
• PULLMAN TYPE, FOLDING, ATHWARTHSHIPS BERTH W/ 5” FOAM, FABRIC COVERED MATTRESS
• HANGING LOCKER
• READING LIGHTS
• AC DUPLEX RECEPTACLES
• OPENING, SCREENED PORTLIGHT
• PADDED CARPET

LAVATORIES

• HOLDING TANKS WASTE LEVEL MONITORS
• HOLDING TANK ODOR FILTERS
• U.S. MADE SANITATION HOSES

ELECTRICAL SYSTEM
CONTINUED

• 1 x 120 AH GEN SET STARTING BATTERY IN PE BOX
• 40 AMP BATTERY CHARGER
• BATTERY ISOLATER

PRESSURE WATER SYSTEM

• PRESSURE FRESH WATER SYSTEM W/ 6 GAL ACCUMULATER TANK
• 250 U.S. GAL MOLDED FRP TANK WITH GEL COATED INTERIORS
• U.S. 15 GALLONS WATER HEATER W/ HEAT EXCHANGER
• FRESH WATER LINES OF QEST POLYBUTYL FLEXIBLE PIPE
• SHURFLO 3.8GPM PRESSURE WATER PUMP

FUEL SYSTEM

• 2 X 415 GALLONS, FIRE RESISTANT, FRP FUEL TANKS
• USCG APPROVED TYPE A-1 FUEL HOSES
• HART FUEL LEVEL GUAGES (NO SIGHT GAUGES)
• RACOR 900 SINGLE FUEL/WATER SEPARATORS- MAIN ENGINES
• RACOR 120 RMAM FUEL/WATER SEPARATOR FOR GENERATOR

YACHT FINISHES

• TWO PART POLYEURATHANE INTERIOR FININSH
• CETOL HIGH GLOSS ON EXTERIOR TEAK

LAZARETTE

• STEERING SYSTEM COMPONENTS
• GFI AC DUPLEX OUTLETS
• 2 S/S LADDERS INTO LAZARETTE

• S/S AND TEAK LADDER TO UPPER DECK
• 2 LEWMAR HATCHES
• 2 FRP COCKPIT HATCHES WITH GAS SPRING HINGES

CONTROL AND NAVIGATION

• F/B & P/H CONTROL STATIONS WITH
• COMPLETE ENGINE INSTRUMENTATION INCLUDING HORN BUTTONS AND AUDIBLE ENGINE ALARM SYSTEM
• HYNAUTIC HYDRAULIC STEERING AND ENGINE CONTROLS
• INTERNATIONAL NAVIGATION LIGHTS
• ELECTRIC AIR HORN

PROPULSION, ENGINE ROOM & BILGE

• TWIN CUMMINS 6BT5.9M 220 HP DIESELS W/ZFHSW 630A GEARS W/ 2.52:1 RATIO
• GALVANIZED STEEL SADDLES MOUNTED ON MOLDED ENGINE BEDS
• CLAMP-TYPE SHAFT COUPLINGS
• 2” S/S AQUATECH 17 PROP SHAFTS
• PYI DRIPLESS SHAFT SEALS
• MOLDED AIRFOIL RUDDERS W/ S/S STOCKS & INTERIOR CORES.
• BRONZE STRUTS & CUTLESS-TYPE BEARINGS
• 4 BLADE, BRONZE PROPELLERS
• RACOR 900FG-2 SEPARATORS
• RAW WATER STRAINERS
• FLEXIBLE,U.S.C.G & CE APPROVED, MARINE FUEL HOSE
• THERMAL & ACOUSTIC ENG. ROOM INSULATION
• FRP DRIP PANS UNDER ENGINES
• EXHAUST LINE SURGE CHAMBERS
• SANDWICH, ENG ROOM INSULATION W/ REINFORCED ALUMINUM COVERING
• 4 X 12V BLOWERS
• 2 X 12V ENGINE ISOLATION SWITCHES
• GFI 120V RECEPTACLES
• 8.0 KW GENERATOR & ACCESSORIES
• 4 EA 110V FLUORESCENT LIGHTS
• FRESH WATER OUTLET WTH HOSE BIB
• 2 EA ATTWOOD 1700 GPH ELECTRIC BILGE PUMPS W/ 12V AUTO AND MANUAL SWITCHES

GALLEY

• TEAK CABINETS WITH DRAWERS AND SHELVES ABOVE COUNTER
• DRAWERS AND LOCKERS BELOW COUNTERS
• LAMINATED SAFETY GLASS
  SLIDING WINDOW
• LIGHTED STAIRS TO PILOTHOUSE
• NORCOLD AC/DC REEFER/FREEZER
• 3 BURNER, ELECTRIC STOVE
• EXHAUST HOOD OVER STOVE
• MICROWAVE OVEN
• DOUBLE S/S SINK W/ SINGLE LEVER, AMERICAN STANDARD FAUCET
• MARBLE COUNTER TOPS

SALON

• “L” SETTEE WITH FABRIC CUSHIONS
• TEAK DINING TABLE
• TV CABINET
• TV & PHONE OUTLET
• LAMINATED SAFETY GLASS IN SIDE AND AFT SLIDING WINDOWS
• AFT, S/S DOUBLE DOORS, WITH GLASS WINDOWS, TO COCKPIT
• PADDED CARPET
• TEAK CURTAIN VALENCES
• ACCESS TO ENGINE ROOM

FORWARD GUEST STATEROOM
TWO STATEROOM LAYOUT IS THE STANDARD.

• QUEEN SIZE BERTH WITH 5” FOAM MATTRESS COVERED IN CLOTH UPHOLSTERY
• DRAWER AND LOCKER STORAGE UNDER AFT END OF BERTH & FWD UNDER BERTH.
• DRESSER WITH MIRROR ABOVE
• PADDED CARPET
• MIRROR ON FWD BULKHEAD
• HANGING LOCKERS
• READING LIGHTS
• AC DUPLEX RECEPTACLES
• OPENING, SCREENED PORTLIGHTS
• TEXTURED VINYL HULL COVERING
• BOOK SHELVES ON HULL SIDES

LAVATORIES
CONTINUED

• MOLDED SHOWER STALL IN OWNERS’ LAVATORY
• CURTAINED SHOWER IN GUEST LAVATORY
• SHOWER SUMP PUMPS
• MOLDED CABIN SOLES
• JABSCO DESIGNER Q/F ELECTRIC TOILETS INCLUDING MACERATORS
• 2 X 24 GAL HOLDING TANKS WITH DECK AND OVERBOARD DISCHARGE & MACERATORS
• EXHAUST VENTS
• MOLDED SINKS & SINK COUNTERS WITH STORAGE UNDER SINKS
• AMERICAN STANDARD FAUCETS & SHOWER FITTINGS
• OPENING, SCREENED PORTLIGHT IN EACH LAVATORY
• GFCI DUPLEX RECEPTACLES.
• TEAK TOWEL RACKS AND TISSUE HOLDERS
• MIRRORED DOOR MEDICINE CABINETS

ELECTRICAL SYSTEM

• 120 VOLT DUPLEX RECEPTACLES
• DC WIRING TO REEFER/FREEZER; BOTH HELM STATIONS; COCKPIT AND SALON
• 1 X 50A/120V SHORE POWER INLET
• COLOR CODED WIRING SYSTEM
• 8 KW GEN SET W/ SOUNDSHIELD; SINGLE STATION CONTROL PANEL; RAW WATER STRAINER AND MUFFLER
• 12V LIGHTING IN ALL COMPARTMENTS INCLUDING ENGINE ROOM
• GFI RECEPTACLES IN GALLEY, HEADS AND ENGINE ROOM
• BONDED ELECTRICAL SYSTEM
• 120 VAC AND 12VDC SYSTEMS
• BLUE SEA PANELS, BREAKERS & SWITCHES W/ BATTERY DISCONNECT SWITCH, BATTERY VOLT & AMP METERS, & REVERSE POLARITY INDICATING LIGHT IN PILOTHOUSE
• INSTRUMENT PANEL LIGHTS
• 1 BANK OF 200 AH HEAVY DUTY ENGINE STARTING BATTERIES IN PE BOXES FOR EACH ENGINE
• 1 BANK OF 200 AH HEAVY DUTY.BATTERIES IN PE BOXES FOR INTERIOR USE